Spring-Set Motor Brakes ideal for failsafe protection on draglines, shovels, and blast hole drills.

•	High energy lining provides long life
•	High torque, low inertia design
•	Quick, simple installation
•	Low stress spined hub
•	Available with taper bore
•	Multiport air inlets available

Ideal for ball and SAG mill applications

•	Extra thick friction discs provide long life
•	High torque, low inertia design
•	Quick, simple installation
•	Low stress spined hub
•	Available with taper bore
•	Multiport air inlets available

Fully-crowned gear teeth
provide maximum contact at the strongest part of the tooth.

•	Models available for use on vertical and/or horizontal shafts
•	Bore capacity up to 510 mm
•	High torque to weight ratio
•	Half per half interchangeability

Low inertia air set clutch designed for Propel motions

•	High Torque, low inertia
•	Low spline stresses
•	Fast response
•	Balanced for high speed operation
•	Integral Rotary Air Inlet

For high cyclic and general clutching duties where space or weight are at a premium.
The LI/HT is designed for end-shaft mounting onto a bearing supported flywheel or gear wheel.

LI High Torque Clutches provide:

•	High torque to size ratio
•	Low rotating inertia
•	Extremely fast response
•	Air applied clutch with full circle friction discs
•	Available in 1,2,3 or 4 plate designs to suit torque, heat, response and space requirements